In active development
Roofing
The operational challenge
Large commercial roofs are slow and hazardous to work by hand. Crews spend hours on access, staging and fall protection before any material is applied, and coverage quality depends on how consistently a person can walk a pattern in heat and wind.
Roof geometry — slopes, parapets, curbs, HVAC units and penetrations — makes consistent coverage difficult even for experienced crews.
How drone technology could address it
Map the roof surface, generate closely spaced flight paths over it, and hold a consistent height relative to the roof rather than to the ground.
Dispense liquid only on planned segments, with the pilot able to pause, take control and resume the mission from where it stopped.
Roughneck Drones is exploring autonomous passes spaced roughly 2.5–3 feet apart as an engineering objective. It is not yet a validated operational capability.
Relevant hardware
Limitations & requirements
- Coating and product manufacturers' application requirements (film thickness, temperature, cure conditions) govern the work; the aircraft must be configured to meet them.
- Wind, rotor downwash and overspray control limit when and where aerial application is appropriate.
- Positioning accuracy can degrade near walls, parapets and rooftop equipment.
- Operations must comply with FAA rules (including 14 CFR Part 107 and any required waivers or authorizations), airspace restrictions, and applicable state and local requirements.
05 · Discuss a project